Mazda3: Разблокировка бортового компа, trip computer на арабке: как включить? Опции

[Morfey1985]

даже на этом форуме читал, что на арабках можно разблокировать борт. комп... только нигде не сказано, как! ПОМОГИТЕ!
очень хоцца расход свой посмотреть...

Сообщение отредактировал YuraL - Apr 5 2008, 16:43

[magic]

Метод 1 не для всех моделей

Only for 06+ Models

1. Get in car and close door.
2. Put key into ignition (DO NOT TURN YET!)
3. Hold down the AM/FM button AND the CD button.
4. With your other hand (while still holding the buttons) turn your key to the ACC position. The Hello message will appear on your display, and as soon as it goes away it will be replaced by DIS ON.
5. You may now let go of the AM/FM button and CD button.
6. Turn ignition off.
7. Turn your car on and drive away!

PS. You will note that you will need to push the "Set" button to toggle through the different Driver Info modes.

2)
- Before you start the engine, hold the CD and AM/FM buttons.
- Start the engine (keep holding the CD and AM/FM buttons).
- After a few seconds, you should see the display read "DIS ON" (driver information system)
- Stop the engine.
- Start the engine again.
- Touch the SET button to see the trip computer.
- Touch the TIME button to see the time.

Your owner’s manual explains how to use the trip computer. With the ignition switch ON, press the SET button (manual says INFO button) to cycle through these 4 options.

- CONSUM CUR: Current fuel economy (calculated every 2 seconds)
- CONSUM AV: Average fuel economy (since battery was connected or resetting the trip computer, displayed every minute, to clear: hold SET for 1+ seconds until the display clears)
- REMNG: Distance you can travel on remaining fuel (must add more than 5.3 gallons to reset it)
- AV: Average vehicle speed (displayed every 10 seconds, to clear: hold SET for 1+ seconds until display clears)